THIS IS A SHENG-WEY BRAND CARB, THE DOCTOR SAYS THIS IS THE BEST IF YOU CAN'T FIND THE OEM KEIHIN BRAND USED BY HONDA.
 
THIS HAS THE 48MM BOLT PATTERN

35MM REAR OD FOR AIR PIPE/FILTER

COMES WITH MAIN JET #68 & IDLE JET #35 INSTALLED

TAKES A 35MM AIR FILTER

THIS CARB USES OUR "SMALL KEIHIN MAIN JETS"

THESE HAVE OUR "322C" TYPE HONDA  IDLE JETS.

THIS CARB NEEDS OUR 300001.5 MANIFOLD TO WORK ON THE CT70'S YOU CAN THEN USE THE STOCK AIR FILTER OR CLAMP AN AFTERMARKET FILTER ON THE BACK. THIS WILL ALSO BOLT UP TO OUR BIG MANIFOLD (300002) AND THEN WITH A CLAMP ON FILTER FIT ON MOST 50'S AND 70'S

IF YOUR PUTTING THIS ON A CT70K0/HK0 K1 K2 OR K3 MODEL,, OUR CABLE S1336 WORKS WITH-OUT MODS. 

sometimes the inner cable length on the stock cable may be a little bit too long for the aftermarket carbs and not allowing for a complete throttle slide lifting, so you may want to get a solder on cable end so you can shorten it if needed... our number is (359E) sold seperatly

Dear dratv,

the carb fit perfectly on my CL90. i did re-use the main jet as it was identical (except orifice size) but the idle jets were different lenghts so went with the one it came with. thanks

- gumpwood59
 
300012
 
TL125'S W/ BIG MANIFOLDS